BM20200 Mobile Container concept

The mobile container concept is unique as it includes transport of both BM20200 mobile roller brake tester and the BM52000 mobile play detector in one transport system - a standard 20" container. The system is supplied to the Swedish Military.

The BM20200 is approved by several international authorities like RWTÜV Germany and complies with the ISO standard.

The BM20200 mobile brake tester is supplied to armed forces from

• Germany
• USA
• Denmark
• England

and operated in areas like Kosovo, Iraq and Afganistan.  The Flattrack concept is purchased by English Army

The robust design of the BM20200 allows it to be placed on gravel ground potentially supported only by small steel plates under each of the six feets.

The brake tester is designed with night light projectors and axle load simulation system power from the electrical power supply.

The display of the BM20200 is normally mounted on a mobile display on wheels, which are placed in between the rollers, when transporting it.

Brochure front page	Brochure back page

Container Concept

The BM20200 mobile brake tester and the BM52000 mobile play detector is transported inside a standard 20" container. With minimum modification and no distruption of the physical strength of the container walls, a transport and load/unload system is build inside the container.

The principle this logistic transport and load/unload system is a two-level system, where the BM20200 is placed on track system over another track system holding the BM52000.

Both the BM20200 and BM52000 is loaded/unloaded by support of an electrical winch and both units are rolled on 50 kg ramps, which are easily placed by the rear door of the container.

The electrical winch is controled via cable remote control, so one person can handle loading and unloading of the brake tester. Additional the container is equipped with a manual winch for backup.

The house is also equipped with special locable transport boxes for tools and calibration equipment as well as printer cabinet and printer, which can be rolled outside if requested. However a self-retractable wire-coil for connecting the printer with the brake tester is placed in the roof by the container door.

The container is fully equipped with 230 VAC and a large internal projector.

The concept can include a generator; Otherwise power supply can be provided by an external generator or from a normal house installation. Power requirement is as standard 3-phase 25 amp.