The design of the BM4010 roller brake tester is unique as it allows for split bed installation over an inspection pit.
This brake tester features a large range of options that allows for a customized configuration.
OPTIONS
Robust and long lasting:
All steel is of highest quality and hot galvanized.
Consists of an integral motorized gear box, two main rollers and a spring loaded sensor roller, all placed in a galvanized steel frame.
The wear surfaces of the rollers are based on mesh steel to ensure a long life time and accurate measurements.
Steel mesh plus a flintstone/bauxite surface for test of all tires except spike tires.
Steel mesh for test of all tires including spike tires.
Can be supplied in a minimum configuration and still allows for later upgrade to all options.
Prepared for test line expansion including suspension tester, speedometer tester and side slip tester all controlled from the same electronics with results shown on one display
Easy to use with BM software:
Integrated guide.
Advanced graphics printout.
Diagnostic printout with or without connection to PC/Notebook.
Calculation of test results according to the requirements of many national authorities.
IT system using latest app technology for smartphone and tablet (Windows and Android).
Split bed roller set makes it possible to install over an inspection pit.
The display can be mounted either on the wall, saving floor space, or on floor column devices, that are designed so equipment is protected even when floor is cleaned with chemicals. It can also be mounted on a trolley making it easy to move around.
Completely flush-floor. When roller cover plates are placed on top of the roller bed, the BM4010 becomes one with the workshop floor making it easy to drive over it from any angle.
Installation
Hot galvanized subframes can be concreted into the ground before the actual brake tester is installed.
The subframes ensures easier planning and implementation of installation as well as correct alignment of the brake tester during concreting.
Can be installed both indoor and outdoor in most environments from -30ºC to 60°C and humidity up to 95.
Fitting adaptor plates are available if subframe is not required.
Applications
Normal workshops performing repair of any light vehicles.